Tooth form _" A" and _" AW"

For thin Metal slitting Saw Blades with a tooth pitch up to approximately 3,0 mm.

Advisable for brass, tooth form _" A" is suitable for slotting materials.

All teeth of tooth form _" AW" are beveled alternatively.

Tooth form _" B" and _" BW"

Suitable for cutting tubes and profiles made of steel or non-ferrous metals.  Tooth form
_" B" is specialized for cutting very thin-walled pipes and profiles.

All teeth of tooth form _" B" are beveled alternatively.

Tooth form _" HZ"

This tooth is also known as form _" C".  Teeth are ground according to the roughing and finishing tooth system.  A tooth pair is consisting of one roughing tooth (1/3 cutting width) and one finishing tooth (2x1/3 cutting width).  According to the triple chip geometry the roughing tooth is approximately 0,2 - 0,3 mm higher compared with the finishing tooth.  Tooth form _" HZ" is suitable for cutting solid materials.

Tooth form _" BR"

Tooth form _" BR" is a parrot tooth with chip breaker.  This tooth form is suitable for cutting pipes under high performance conditions because the teeth are side cutting.